Little update, I had a family member in the hospital this week, so I didn't get the first 5 boards sent out as soon as I'd hoped, but I'm dropping them off tomorrow. The factory sent me pictures of the boards that they are currently working on, so I'm hoping that they will ship very shortly.
Otherwise, (as before) I'm waiting on standoffs from Aliexpress. I'm obviously hoping they arrive before the PCBs, but trying to communicate with those sellers can be difficult.
Additionally, I discovered the location for my mounting holes was a little too tight between the switches when using MX clones. All of my pcbs (until recently) I had assembled using box switches. When I assembled a board using zealios and zilents I found that when I assembled them, some of the switches were skewed. This is because the screws were pushing into the switches when the plate is attached to the standoffs. I managed to find some smaller screws that are hex heads, and tested them... so crisis averted. All boards will ship with the new screws and a wrench (including the 5 going out tomorrow). Obviously none of this will affect anyone putting together a keeblade, but you'll get the proper screws regardless.