When I install SIP sockets, even when inserting the switch fully into the PCB the ends of the sockets barely make it through the PCB holes. Is that everyone else's experience as well? It seems like it puts the connection to the LED at risk unless you really get in there with the solder.
Yes, on a 1.6mm PCB it will basically be flush with the bottom of the PCB.
I am using a sprit PCB, so the led holes are all the way through so there is lots of surface to solder to. No issues at all. Desoldering them is a bit of a PITA, but I think that is to be expected.
If you have a single sided PCB then I could see you maybe having some issues.
Which PCB are you using and do the pads go through the PCB?