[GB] KIRA80 & KIRA S

[sroop]

It's in the thread somewhere, unless beaming deleted it.


Sent from my iPhone using Tapatalk

I've been skimming through the pages and could not find it, hopefully it's not deleted.

Here ya go, just have to click the link to the original post though

I got my board last week and found some scratches on the plate.
zF quality control seems not good.

thesiscamper: do you have plan to share plate data?

Show Image

I don't think EVE changed anything (ie. screw holes), I've attached the file.

edit: to the guy who downloaded the earlier file this new attachment might work better.

[beamingrobot]

Thanks sroop, I'll link to it in my OP as well.

[Etherealsound]

Thank you so much! Just one last question, anyone know around what thickness the brass plates were?

[forevermadrigal]

Thank you so much! Just one last question, anyone know around what thickness the brass plates were?

Standard 1.5

[elmo]

Hey everyone 

For those that don't like Bootmapper or just prefer QMK in general:

I did the work and ported the original Kira 80 PCB to QMK.
https://config.qmk.fm/#/kira80/LAYOUT_tkl_ansi

https://github.com/qmk/qmk_firmware/tree/master/keyboards/kira80

board is fully supported now and everything works (including backlight). Can be flashed using the bootloadHID tools (included in qmk).

[SBN]

Hey everyone 

For those that don't like Bootmapper or just prefer QMK in general:

I did the work and ported the original Kira 80 PCB to QMK.
https://config.qmk.fm/#/kira80/LAYOUT_tkl_ansi

https://github.com/qmk/qmk_firmware/tree/master/keyboards/kira80

board is fully supported now and everything works (including backlight). Can be flashed using the bootloadHID tools (included in qmk).

Awesome!! Thanks!!

[schlep]

anyone has a spare pcb to sell by any chance?

i may have damaged the lctrl button in my desoldering process. tried remapping and flashing again but the lctrl still doesnt work.

[shansoft]

anyone has a spare pcb to sell by any chance?

i may have damaged the lctrl button in my desoldering process. tried remapping and flashing again but the lctrl still doesnt work.

You can get the h87a or SUO PCB for it.

[beamingrobot]

Hey everyone 

For those that don't like Bootmapper or just prefer QMK in general:

I did the work and ported the original Kira 80 PCB to QMK.
https://config.qmk.fm/#/kira80/LAYOUT_tkl_ansi

https://github.com/qmk/qmk_firmware/tree/master/keyboards/kira80

board is fully supported now and everything works (including backlight). Can be flashed using the bootloadHID tools (included in qmk).

I've linked to your message in the OP, thanks for doing this

[schlep]

anyone has a spare pcb to sell by any chance?

i may have damaged the lctrl button in my desoldering process. tried remapping and flashing again but the lctrl still doesnt work.

You can get the h87a or SUO PCB for it.

Thanks for the advice on alternative PCB. Any alternative plate?

[forevermadrigal]

Find one the aftermarket or get the plate file and get one made yourself.

[Little4Real]

At this rate, just make them SA profile

[Bubblegum]

Has anyone tried having a PC plate cut from the plate file? Curious of the results. Never tried an 'after-GB' PC plate for a top mount TKL before.