1) How many Amps (operating current) does it consumes while connected wirelessly at about 1-2 Meters from the PC in a plastic case and all the lights off?
2) Is it possible to be used while the battery is charging ?
3) (Dumb question) Does the PCB detects when the battery is fully charged and stops charging it ?
4) Does it have anti ghosting (NKRO) wired and wirelessly? If yes, how many keys in each mode?
5) The BT 4.0 works on both iOS and Android devices with 4.0 ? Normally there must be a manual switch telling the pcb to which OS i want to connect.
6) Does it need a dongle to be bought separately like the Anne Pro 2 ?
Apologies for making so many questions, but i am really interested in supporting the project.
A full build log also would be nice.
Sorry for the late reply
1) 6ma when typing, 1.9~2ma when not typing.
2) Of course, once the USB cable is in, the charging will start and you can use the keyboard as a USB keyboard.
3) There is a battery management chip on board, it will control the charging current and voltage, or it can be very dangerous to charge a Li-Po battery directly by the USB voltage.
4) Currently, the NKRO feature is not enabled yet, it will be enabled by a future firmware update, and I'm quite sure that it won't work in Bluetooth mode.
5) You would check this with your device vendor, as I know, Most Apple devices you can buy nowadays(later than iPhone 4S) will support BT4.0, Android devices after 4.3 will support too, but it might not means all the devices will do.
6) It depends if there is a Bluetooth adapter on your computer. If not, you certainly need to buy a Bluetooth dongle to enable Bluetooth on your computer.
