Scuffed my DZ60

[sowon]

Hi, sorry if this is in the wrong sub but I'm in a bit of a pickle with my new $350 board and I'm getting increasingly nervous about bricking my new PCB.

I got my new keyboard with a DZ60RGB-ANSI PCB all installed, and I tried flashing QMK Firmware using QMK Toolbox, and it told me to do Esc + input cable and at that point was when my PCB stopped working.

Windows now spits out an error saying unrecognised device on both my PC and my Manjaro Linux laptop 

Any help is much appreciated!

[rxc92]

Is there a hard reset button on the PCB itself? If not, you can manually reset it by connecting the two leads with a paper clip.

[Sup]

The new DZ60 has a reset button you need two connect the two pins it's somewhere in the middle of the PCB. It's best to compile a new hex file and flash it. Everything should work again like normal after that.