« Reply #153 on: Mon, 11 January 2021, 13:23:18 »
Can this be used for Abel-X?
YMMV
There were some questions posed about the 1.2og pcb working in AbelX. I am currently using a 1.2og yellow pcb in my abelx, albeit there are some caveats.
- For alphas everything is fine
- For tkl cluster (arrows, print screen/delete etc) spacing is off
- I had to cut and trim the pegs in switches to make them fit, but it works
- Mini-USB port sits further back on 1.2og pcb compared to the abelx pcb, which extends the mini-usb port out about 1cm. Usb ports align, however, which means if you have a small cable it works fine.
I would not recommend doing this, but if you are in a pinch and want to use your abelx, a 1.2og pcb will work...sort of
Hope this helps, and gives some closure to the issue.
edit: I figured it was obvious, but without some janky hand wiring the leds will not work...as there are none on the board.
Logged
[Mostly] Retired from Keyboards
Typing on: TKL One - Zealios v1 - 55g TX Springs, TX Films, Lubed with 205g0 - Xiami Beige Cadet + RGB
Collection: IDB60 (gone), Austere (gone), Matrix 1.2og (gone), Matrix 2.0add (gone), RS (so lit), Infinitum (gone), THRILL Proto (destroyed), Matrix 2.0add xmas Starry Night (gone), RS60 (traded), MC65 (traded), Jane v1 CE (gone), GSKT-00 (gone), TKL One Poly (returned), TKL One, RS60, Serenity Proto, Boulevard Proto