Yeah, we found out about the issue with right when they started getting to people.
Basically, the problem was, these cases are different than all the other 60% poker cases and we didn't anticipate this (this case was added near the end of the drop).
Rev 2 of the Infinity 60% has the diode issue fixed (which should deal with the usb problem as well).
The original buyer had the option of contacting support and getting one of the newer rev 2 pcbs (I think there were only 10 people who bought this case, everyone else shouldn't have any issues). You might be able to contact the original buyer and have them request a new pcb from Massdrop support (rev 2 should be shipping in the next couple weeks).
Personally, I can't really handle any of these issues.
You could also try soldering different diodes and repairing the USB connector, but that's up to your own soldering skills.
Thanks a lot for the reply, this issue frustrated me a lot, I had really high hopes for the infinity, getting them crushed wasn't easy
I will contact the original buyer to explore that option, yet I'm not too optimistic, the main issue in my personal case is the import process, it takes long and it's risky, there are also limited chances for imports, after a while they start halting everything at customs, apart from this issue, the 60% case I ordered was missing screws, which amplified the sadness (I managed to find compatible screws, yet it's unclear whether the thread count is really compatible, if it's not, it will likely render the case unusable)
The PCB has a lot of wiggle room, the plate mount is also very loose, probably to let the switches to be opened, with this 2 combined, using plate mounted switches is madness, I sincerely hope massdrop is going to send PCB-mount switches this time, but I don't think that will be the case, this is why all the assembles infinities online have skewed switches/keycaps
I will probably reflow the problematic diodes now, de-solder all the switches, put PCB-mount ones and hope no more issues pops up
The plate also seems to be missing the left-hole for the leftmost 60% case screw, why is this?
Edit: Finally purchased a desoldering station, can't go on with the pumps any more