Seeing the progression of your work makes me happy! I see the dedication. Awesome!
Thanks!
What is the most common issue youve found in the failures?
They never had the drive to make something of themselves.
Thanks Romevi, now I can go to bed after a solid lol
Oh man, I wish I had read this last night. Seriously laughed out loud when I saw this this morning.
But to answer your question, it depends. A lot of these aren't even caps. Remember when I royally ****edup my first mold? Well I kept pouring resin into the 1st part of it anyway just to practice.
Lots of them have bubbles, thats been solved, mostly, by better equipment.
Some of them weren't mixed correctly, as in they are still sorta flexible.
Some of the had issues when trying multi shots, which happened because I tried to mix the very least amount of resin I could... That didn't work out.
I also had an issue with a mold, so some of them have this extra tall kinda lip thing around the bottom.
And a few didn't have quite enough resin in them, so when I put them under pressure there wasn't enough in the sprue hole to make a fully formed cap.
My personal favorite though was when it was colder in the basement and they were still maleable after 2 hours in the mold (using 326) so I squished one
So yeah, I'm sure there are plenty of other mistakes that I have yet to make but no one thing aside from their general lack of drive
Thanks @Romevi for that
Haha, this is a great photo