Morning from Taiwan guys!
We are planning to start CA66 GB on 15th.
)
My mate will be going to anodizing factory to check all final color options.
And we'll be uploading modded plate and alps plate pics for you guys to have a look.
About PCB, there will be 2 kinds:
1. Normal wire version: with modded RGB led strip and a bit change for fully supporting QMK. USB C to C also supports
2. Bluetooth version: BT4.0, compatible with MX switches and ALPS switches. TMK firmware.
About Hotswappable PCB. Since CA66 wasn't designed for using this way to install and build, the PCB will need some screws to mount to the top case as you guys can see what m60-A did. It should be re-layouted and tested, which is going to cost lots of effort.
We don't think it's a good idea to just produce some PCBs, and you guys are on your own after sending them away.
So sorry to say HS PCB is not available. We'll come up with it in other design to follow the trend.