Hi guys. I am a bit sick so I won't be able to reply very soon to both Facebook fanpage messages and replies this thread.
It's quite taking up my energy to check replies one by one.
But if you got any problem and you can't find a solution in thread, contact me via FB messages and email.
These two ways will get you a quicker reply.
As most of you had got your board.
Please do test your PCB by following these steps before starting your build (make it as a habit is better to every custom PCB):
1. Every PCB should include a main board, a daughter board and a flat cable.
Plastic washers are for screw in stabilizers to prevent shorting.
2. Check out flashing guides here:
http://bit.ly/2W9tSet and flash PCB with your hex file once. That way you can fully test your PCB and don't have to ask what's the function for every key.
3. These two guides were for PCB of last round. There are some changes for bettering it in this round.
I will try to make a new one and tell you guys where are differences for you to play with.
Thanks.