Is anyone else having an issue with their Bluetooth PCB disconnecting itself and quickly re-connecting over a wired connection? I have not connected to any Bluetooth devices yet, and have tried turning off Bluetooth but the issue persists. It also happens with different laptops and with different USB cables.
Are you using the correct firmware (CAD66) from ydkb.io?
http://ydkb.io/?cad66
Sent from my Pixel XL using Tapatalk
Yes sure am. I think in an earlier post Barry mentioned firmware updates but am not certain if this is firmware or hardware related, perhaps a poor power connection.
Have you tried using the board outside of the case? I haven't gotten round to using my BT board but I'm a bit sceptical of how reliable the connection will be, considering the placement of the module and the amount of alu almost completely surrounding it
Sent from my Pixel XL using Tapatalk
I noticed the same issue while outside the case too. Come to think of it, I think I had the same problem with one of my R1 PCB daughter boards, and swapping the daughter board got it working. I only have the one BT PCB daughter board however so some more in depth troubleshooting is in my future.
If some of you still face the same problem, please check some following points:
1. Test wire mode without battery plugged in.
2. Make sure there are no positions shortened.
3. There is a small space beside connector and case, but still there's a chance of it being the problem.
Also, bottom row will be very close to bottom plate when bottom plate is been screwed up.
Make sure bottom row switch pings don't connect with bottom plate.
4. Making sure grounding wires in your house are connected properly and correctly.
If not, it will also cause the problem.
Are the website GB's dates for 2018, or are they current?
2018. They are being delivered now.
Sent from my Pixel 2 using Tapatalk
Thank you for the feedback. It appears that the set can still be bought at the website. I hope for a third round.
There won't be. Sorry.