That looks really nice. I wish they had made the gap smaller though.
Can you notice the lack of support in the middle? Or does the plate cover that up pretty well?
It does have a gap in the front relative to the back. When the pcb sets into place with the case/usb port it forces you to have the off alignment with the front and back gaps. I would say that it doesn't look as bad compared to the cheap Aliexpress 60% case because the side gaps are even and reasonably tight (the cheap Alexpress case has uneven mounting and uneven gaps). The difference between the front and back gaps are only noticeable when you look directly down at it from overhead and because it's a higher end case it doesn't seem like a big deal. My IBM model F XT has a huge gap on the left side of the case and I honestly never bothered to try and fix it because the build quality as a whole is so nice that it doesn't seem to detract.
If it’s only like that in the front it’s not so bad. It was hard to tell with the perspective and shadows.
I hope they do some bright colors next time. I’d love a nice neon pink for laser. Or a lime green.
Sent from my iPhone using Tapatalk