Thanks for the love and support everyone
There are a few things I would like to address here. For the wood material, we can confirm we will have black walnut for GB. We are now waiting for the factory to send us some more wood samples, we'll update again when we have them in hand!
Just a question about the finish, the product used to finish it is just an oil/wax right? So I could apply some polyurethane to it right? or does it already have poly?
Sorry for our confusing wording it was actually Osmo's hardwax oil we'll be using, and yes it will be the only finish we apply on the case. In our opinion since it's hardwax oil, we wouldn't recommend adding an extra layer of polyurethane.
Interesting. If black/dark wood (e.g. black walnut or ebony) and if walls covers fully the switches. I'm in!
Things that i would change are:
- That angle, doesn't match at all the rest of the design
- Would prefer no engrave at all if this is the only engrave we can have (or would pay more for a custom engrave)
Show Image
I agree with the comment about the curved surface on the back. It does not really fit the rest of the design imo. A straight back or a sharp angle would be a better fit! Apart from that this is a really nice case, and I'm defenitely interested in getting one when it is possible to do so :thumb:
We were considering a straight back or sharp angle before...however as most of the wood cases are already in straight back, we wanted to have something slightly different this time. We are aware that the uniformity of the design is affected and therefore has been carefully adjusting the curves to a comfortable angle, particularly for touch and feel. Straightback is appealing, but perhaps next round :)
About engraving, we'll need to come back to you later on that, we'll keep it on our update list for the moment.