Anyone get the programming figured out yet. I know Small Fry was close at one point. I can do most of the basic stuff but can't get the LEDs setup the way I want. There were posts asking for help but we keep getting told to go to the mfg's website. Personally, I don't do Korean too well. With this amount of money changing hands it certainly should not be too much to ask someone involved to take a couple of hours and give us an English manual. Am I wrong here?
The problem I am having, after soldering the LED resistors is dimness, as alaricljs mentioned in a post. I can hold down the ESC for 5 seconds while powering up to reset it and get the desired brightness but then I only have basic scroll lock / caps lock functioinality. I am attempting to illuminate the entire F row. I have tried all of the modes in the software but they are too dim. Also, they don't seem to save to the kbd properly, meaning when I unplug and replug they don't come back how they were before. Also, what if the F/W button in the software do?
John