NEW USERS, READ THIS!
0 Members and 2 Guests are viewing this topic.
Quote from: Latin00032 on Wed, 22 May 2013, 22:22:21Do you have any pictures to give me an idea of how the USB cable will work with a Filco or QFR?It works exactly the same as how it would work on the filco.. the final phase of this prototyping is only anchoring on the design of the bottom layer to accommodate teensy, filco and QFR cabling issues. And yes also about the colour combinations. I'll post pictures after I'm done with work today.
Do you have any pictures to give me an idea of how the USB cable will work with a Filco or QFR?
wut. i'd buy a ****ty IBM board for that green V2
takaki, do you have pics of the inside without the keyboard mounted? I'm asking because if it fits a quickfire TKL, then it might not work for phantom because the edges of the plates are different. Stock Filco and CM plates have a small right-angle bend on the front and back, my Phantom plates are just flat. I don't think you mentioned standoffs, so mounting phantom may not work.You should get my plates soon. It was one of the first ones I shipped out
The current casing height is measured at 18mm then you add the height of your keycaps. I am going to add another 10mm tall rubber feet to act as feets which is totally optional if you don't like feets.Colour samples in my bag.. Must say that neon green + white centre with orange bottom layer reminds me of gummy burgers.
the feet will be stick on, removable of course.
Basically, the centre portion can only be either opaque black, opaque white or clear.The top layer and bottom layer can be customized
I know this has likely been covered, but how much is this case going to cost?
the local most bang for buck acrylic sheet manufacturers don't have pink and purple sheets, gonna source elsewhere. Just submit the interest check form, I'll mass email / pm when it is ready to go.
What if we didn't fill out an IC? I wasn't sure what to choose since I think I'm one of the few that wants winkeyless w/ numpad.
What about 86 key layout?
So I watched a comparison video and concluded Filco and QFR boards are made by Costar but the Filco has a few more screws in the assembly. I don't know how the attachment to this acrylic case is but is there any chance if it would fit a Ducky TKL (US ANSI) model?
may i know the progress on the case ?