Quick building question. For some reason after taking this keyboard apart and rebuilding it a few times over the last couple of weeks, the enter key no longer registers keypresses. It's not the switch, because I've swapped it a few times. It's not the software, because it works fine on an identical keyboard with the same pcb (Satan 60).
So my solution was to put two switches in the enter position, and skip the stabilizer. Great, right?
Yeah, except now the enter switch no longer fits, since the holes don't align.
My so far I've been using two 1U caps, but since the first one has no effect, I find myself having to stretch my pinky far over to hit the second one.
If I could, I would connect the two 1U caps so that if I press one, the other one also goes down, but that would actually require the stabilizer which no longer has room to work...
So now what?