Did some machining today, alps clueboard case + some 60% plates.
so,
working out toolpaths.
cutting, you can see my previously cut out atreus pieces.
and the cuts, not finished yet I am just going to brush them down with a few scotch brites to get rid of the burrs. stuff I made was a hhkb 60% plate, AEKII plate and the clueboard case, all out of ~1.2mm alu, all turned out pretty clean. note: the hhkb plate looks pretty bad because its the bottom and the waterjet cutter does these sorta sandblasted marks on the bottom of the pieces.
mockup of all the clueboard pieces before I machine the middle pieces out of wood.