Hi,
I'm new here and I hope, it's the right sub forum. I googled a lot, but still havn't found any good solution..
I want to reduce the way of the MX Switches to eliminate the senseless way after keyactivation.. activation point is 2mm, after that 4mm (?) way doing nothing than press and waste time..
I tried O-Rings, tried other sort of rings layed on the board instead around the insiode of keycap, but don't really work as I want. Before testing I thought the way reduction is equal to the strength of the ring, but it's much less..... And big O Rings has the problem to cover the LED lighing. I also read about landing pads, but sounds like the same problem with o rings, that they are only to reduce noise, but don't reduce the way too much (I know, most like that).
Do you have an idea or is there maybe a buyble solution to reduce the way without covering the LED lights?
My main problem is, that I don't know, which part of key is "hitting the ground" - means, which part I have to manipulate to make it stop earlier. I thought it's the key inside, that hits the 'plate' around MX switch, but it isn't... Maybe somebody can explain.
Greets,
Ovi
PS: sorry for my bad English, I'm German.